Because you have incorrectly named the ghost file *.GOR.The saved Ghost file could not be found in the computer. In the process of ghost running halfway, it says: 'unexpected end of file if this problem persits, contact symantec technial supports at '.Ĭause: Your ghost version has been corrupted, choose another version for ghost to try again. This error occurs when you go inside Norton Ghost to select the ghost file from the cd, it shows Not disk drive were detected.
#Norton ghost issues install
This is a RAM error, although Windows has not been damaged, and the machine is still running normally, many people mistakenly think that the ghost version is not compatible with the machine configuration.įix: Try to install another stick of RAM if the ghost is good, buy only one, the diagnosis is correct. The machine often reports an error halfway when ghosting, this error is usually a RAM problem, possibly due to a small amount of RAM, or old RAM.Īnother common error is that after successfully extracting the ghost, when entering Windows, there is a blue screen of death error (blue background + white text on half the screen).
#Norton ghost issues how to
How to fix: Replace the new hard drive, because honestly, Bad Sectors error is very difficult to fix even if you cut the bad segment, but it can die at any time and affect your data. If it still doesn't work, it means the hard drive has a problem. You try to bug another ghost to see if it works. Error due to hard drive (HDD)įaulty hard drive (a common error is Bad Sectors) is also a cause of errors when ghosting because the ghost file has damaged data structures, making the program unreadable. How to fix: See Set Active instructions for the partition. This error is caused by the hard drive you just bought, not partitioned or your hard drive has not been set active. Ghost partition is dimmed, not for ghost. Conduct bug file ghost.įor Hiren's Boot disk from 10 or more: Select Dos Programs > File managers... then follow the same steps as above. How to fix: Proceed to mount the drive: boot from the Boot disk, select boot CD, DVD.įor the old Hiren's Boot disk (version older than 10): You select File managers (item 8) => select VolKov Commander 4.99 (item 1) => select Yes, select Readwrite => select Yes => press the F10 key = > reboot the machine. This is a classic error, which many people even many skilled technicians sometimes succumb to. When the ghost file bug, we only see the partition containing Windows, the remaining partitions are empty even though we have not deleted or formatted these partitions.
When you create the ghost file, the machine gives the error 'Dismount disk' and does not allow the file to be created.
Solution: Remove the cable, reattach both the signal cable and the power cable to the hard drive, if it still doesn't work, replace the cable with a new one. If you bug the ghost file and don't see any partitions, the main cause is cap. Error due to data cableįor ATA-generation hard drives, older IDE cables are more likely to fail than SATA hard drives. Today I will share my experience to help you fix and avoid some common errors in the ghosting process. For you Technicians, ghosting is a regular thing.